The latest issue has the HB stainless model reviewed.
Not an overly positive review - I didn't realise the 'laminated' thumbhole stock was actually just tarted up plastic.
FMD.
17wsm
-
fenring
- Moderator
- Posts: 2607
- Joined: Sun Jan 07, 2007 2:50 pm
- Location: Central Victoria, Australia
Re: 17wsm
Guns Australia were less than impressed by the original B-mag.
The latest issue has the HB stainless model reviewed.
Not an overly positive review - I didn't realise the 'laminated' thumbhole stock was actually just tarted up plastic.
FMD.
The latest issue has the HB stainless model reviewed.
Not an overly positive review - I didn't realise the 'laminated' thumbhole stock was actually just tarted up plastic.
FMD.
-
brahman
- .22 WMR
- Posts: 124
- Joined: Wed Apr 29, 2015 8:14 pm
- Favourite Cartridge: 222
- Location: orange n.s.w
Re: 17wsm
so dam close to getn 1 iv held off for a while now been hearn some good stuff on the rugers just main prob is the trigger and shim the bolt but the main is the trigger if i get to the expo next week end that will be the decider
-
brahman
- .22 WMR
- Posts: 124
- Joined: Wed Apr 29, 2015 8:14 pm
- Favourite Cartridge: 222
- Location: orange n.s.w
Re: 17wsm
ok yesturday i went into the lgs to buy some gear which i did and its finally happened iv bit the bullet did my pta and put a depost on the 17wsm ruler so now the wait begins and the build begins so new trigger timely or jard whats your pinion bolt shims and the big 1 what scope lookn at the meopta meopro 6x18x50 atm 
so if all goes well in-between now and missathon it should be there for it
so now the wait begins and the build begins so new trigger timely or jard whats your pinion bolt shims and the big 1 what scope lookn at the meopta meopro 6x18x50 atm so if all goes well in-between now and missathon it should be there for it