AusVarmint

Glenn wrote: ↑Mon Apr 01, 2019 4:33 pm
YOUR using a 6x47 Lapua????????
From ALL your previous posts I was under the impression that case woefully inaccurate?

I think you will find he was referring to use for long range BR not plinking

Hi Con

While the manufacturers have their standard profiles, my experience is you can ask them for a specific profile and they will manufacture to that. Probably just pay to speak with your supplier.

Alright then, suggestions for dies, projectiles For dies I have the Redding type S match die set. Comes with neck bushing die, body die and micrometer seater. As for the projectiles my reccomendation for LR comp would be the copper head 103s and that is after shooting the sierra 107s, custom comps ...

Nothing wrong with the Omark Trev as far as accuracy. When I ran mine as a 30cal never had any issues with extraction and regularly agging in the 6” area. Just when you push them hard pressure wise extraction can become bit of an issue.

Hey Camel I would say of the reamer choices you have go the straight BR. As Tony said don’t even start without bushing the firing pin, been there done that and had to bush mine. The other thing to consider with the Omark is their extraction. I have found on mine when pushing things along with the st...

Hi Jeff

Weather was the typical heavy mirage for February / March up here with the humidity. Winds were a switching down range to a switching head wind. Standard thing of 6 different conditions being shown from 5 flags with up to 12” of unexplained vertical thrown in for good measure

I have never painted a manners though on all my composite stocks I have used 2 pack automotive paints.

We have made a change to our shoots each month and will be alternating between 600yd and 1000yd each month / shoot. On the months that we shoot 1000yd we will be shooting 4 targets. This month was a 1000yd match with the results below. Appologies to Tim, I can’t remember your last name 🙄 34CE887F-0C...

Final results for the 2018 year 6 match aggs.

1000yd

600yd

Glenn wrote: ↑Mon Dec 31, 2018 1:51 pm diewax_580x@2x.jpeg

And don’t believe Glenn as no amount of lube is going to make it fit....

Well can we guess what die killed each case

I go left to right - collet, ackley and then bushing die

Don’t listen to them Trev.... especially Mr Saligari, i saw him break the handle off his bolt while trying to fit his sized brass in his gun :lol: and I have killed a few over the years forming them for my comp guns :oops: The issue you have is all your die set ups were wrong for the process you wer...

Hey 🐿

As Missed said I sold it to Camel some time back and I don’t think he had the chance actually build a HG and use it due to being too busy feeding sheep due to the lack of rain.

Maybe one day we will see it back in service knocking down some small groups at long range.

1000yd results from yesterday



600yd results from yesterday

Hi Gary the belt speed should be around 2950 surface feet per minute that I calculated on the motor speed of 2825 rpm and the drive wheel diameter of 4”

Here is a quick vid to show the speed it is doing:

https://m.youtube.com/watch?v=9exg_pSEAYY